Knowledgebase
PCI Conversion Utility for FARO 5.1
Posted by Brian Sloman on 31 March 2016 08:59 AM

PointCloud users with a FARO Laser Scanner can convert their FARO point cloud files (*.FLS,*.FWS) to PCI format using this application. This version supports the FARO 5.1 format.

Note: This installation requires one of the following products to be installed prior to installation of the PCI Conversion Utility.  An error stating "A required component was not found" will result during installation of the PCI Conversion Utility if one of these specific products are not installed:
- PointCloud CAD 2010 SP3 v10.2.0 (download here)
- MicroSurvey CAD 2010 SP2 Ultimate v10.3.0 (download here)
- MicroSurvey CAD 2010 SP3 Ultimate v10.7.0 (download here)
- MicroSurvey CAD 2013 SP1 Ultimate/Studio v13.2.3.0 (download here)
- MapScenes Point Cloud 2010 v10.4.0 (download here)

Link: http://s3.microsurvey.com/pciconversionutility/pciconversionutility-faro-1.0.3.1-enu.exe


Installation Instructions:

Step 1: Download and install any one of the compatible MicroSurvey or MapScenes products listed above.  (Even if you have a newer version installed, such as MicroSurvey CAD 2013 SP1.1 or MapScenes Forensic CAD 2013, you must also install one of these older products.  You do not need to actually use this older product, but it must be installed on your computer.)

Step 2: Download and install the PCI Conversion Utility from the link above.


Conversion Instructions:

Step 1: Launch the conversion utility from Start | All Programs | MicroSurvey | PCI Conversion Utility for FARO.

Step 2: In the conversion utility, select your FARO .fls or .fws file as a source file. The conversion utility will create a .pcg file and a series of .pci files.

Step 3: Launch your MicroSurvey product, run the Point Cloud Linework command, and open the .pcg file.

 

Please see this movie for an overview of the steps:

(0 vote(s))
Helpful
Not helpful

Comments (0)