`
Start a conversation

Surfaces & Volumes

  • Surface Formats Supported by MicroSurvey Products

    All MicroSurvey Products allow for import of surface files. Two formats are supported, see the table below for a summary of capabilities: Product Version Imports Exports Staking Surface Display Volume...

  • Landxml Surfaces in MicroSurvey Products

    All MicroSurvey CAD and Field products allow you to work with surfaces.  The two supported formats are *.QSB (a format saved by MicroSurvey CAD Products) and Landxml (a universal format defined by Lan...

  • Cut and Fill volumes

    You can easily compute cut and fill volumes between two surfaces in MSCAD, and express the results as contours, 3d rendered dwg entities with colour coding, or output a spreadsheet showing cut and fil...

  • Creating Surfaces with Elevations Close to Sea Level

    If you have elevation values close to sea level (0 elevation) you may notice you have trouble creating a surface. This is because MicroSurvey has a default elevation filter that prevents inclusion of ...

  • Scale the elevation of Lines, Polylines, CAD Points and other linework with SCALEZ

    SCALEZ is a good tool to convert any 3D linework to 2D....

  • Configuring Modeling and Surfacing Settings

    The options found under MsModeling > Configuration Settings have a powerful effect on how modeling and volumes routines perform: Changes to these settings normally reset when the program is closed, bu...

  • Error: Rejected Function - while smoothing contours

    If you run the Smooth Contours routine (SMOO command) and you get some contours being smoothed and then the error message saying error: rejected function, try the following: Go to the Settings menu | ...

  • Volume Calculations - Tips, suggestions and stuff...

        There is some confusion about which of the two volume calculation methods to use for many jobs.‚  You have the Area Volume and Surface Volume commands, and many use the wrong one when trying to ge...

  • Contouring at or below elevation zero

    Q) I need to create contours for the bottom of a lake. I already know how to do normal contours for most jobs but if the lake elevation is at zero elevation, how do I do the contours below zero? A) By...

  • Labeling Contours

    I have had a few customers call with problems relating to Labelling Contours. The problem is not the labelling command but it has to do with the contours and whether or not they have been smoothed. If...