Start a conversation

Error: Rejected Function - while smoothing contours

If you run the Smooth Contours routine (SMOO command) and you get some contours being smoothed and then the error message saying "error: rejected function", try the following:

Go to the Settings menu | Drawing Settings | Entity Modification tab | Change Settings For: Spline/Fit | Number of Points per Curved Segment - set this to 8 or 10. 

The above error will occure if this setting is too high.  Now rerun the smooth contour routine and it should work for you.

Choose files or drag and drop files
Was this article helpful?
  1. Migration Agent

  2. Posted
  3. Updated