Knowledgebase
Alberta Digital Submission for plans
Posted by Jason Poitras on 05 September 2007 03:18 PM

I am an Alberta Land Surveyor and we now use digital submissions for our plans. To make this easier, I heard that you now have the ability to map layer names to new layer names and check the job later to make sure that everything is on the correct layer. Where can I find this?

If you go under the MicroSurvey menu -> down to Layer Control -> Mass Layer Conversion, you will find the commands allowing the layer mapping and object correction. The help file and reference manuals have information about these new commands.

(156 vote(s))
Helpful
Not helpful

Comments (0)