The prompt for the Drawing Scale when you start a new drawing, is used to define the height of all lettering and symbols. The linework in all cases remains at full scale so you can measure between poi...
You can type %%D, %%P and %%C in the text command. Not all fonts will permit these characters. If you're using a true type font you can use the following: Press ALT key + 0176 for the degrees symbol. ...
Type in the command TEXTMINDISP and set the value to 0....
Multiple Perpendicular Ties gives you a report showing baseline and offset values for a range of points, relative to a baseline you've established by typing two point numbers. It is found under MsAnno...