The Stonex S10 GPS reciever has a special utility tool to calibrate the sensor's tilt compensator. This calibration tool requires multiple steps to complete and must be preformed on a data collector r...
FieldGenius, Layout, Seismic Surveyor and Evidence Recorder can connect with the Topcon ES. Please note that Rapid S EDM mode will not be available. To prepare the Topcon, follow these steps: 1. Go to...
This guide describes how to configure MicroSurvey FieldGenius to collect Stop and Go GNSS data using a GeoMax Z25 GNSS receiver. The goal is to import this data into GeoMax Geo Office for later post ...
This guide describes how to start Kolida FieldGenius on your Kolida total station, create a new project, setup your instrument over a point, measure a backsight, and start surveying. This is the perf...
This guide describes how to connect a Leica iCON 50 robotic total station to a Leica CC51 data collector using MicroSurvey Layout and Long Range Bluetooth. This guide actually describes 3 methods of c...
This guide describes how to connect a Leica Builder total station to a Leica CC50 data collector using MicroSurvey Layout. This guides describes 2 methods of connecting the Builder to the CC50. The ...
This guide describes how to connect a GeoMax Zoom80 robotic total station to a Getac PS236 data collector using MicroSurvey FieldGenius and Long Range Bluetooth. In this guide you will learn how to co...
Step 1: Enabling Geocom Mode: To work with Geomax Zoom 80 you must obtain an extended Geocom license from Geomax. Copy the license file onto the instrument CF card as per the instructions that were in...
This guide describes how to create a robotic total station profile using a Leica TS15 robotic total station, a Leica CS15 controller, and MicroSurvey FieldGenius 2012. This guide will work for both th...
Follow this guide to configure the Geomax Zoom 80 to connect with each of the following Data Collectors: Allegro MX with a Leica Radio module Geomax Zoom 80 C Controller Leica RX 1250 Controller (use ...